ISO 13511:2025
International Standard
Current Edition
·
Approved on
19 March 2025
Petroleum products and lubricants — Rheological properties of lubricating greases — Determination of the consistency of greases with metal soap thickener by an oscillatory rheometer with a cone/plate measuring system
ISO 13511:2025 Files
English
14 Pages
Current Edition
121.34 USD
ISO 13511:2025 Scope
This document specifies a procedure to determine the consistency of a metal-saponified lubricating grease by an oscillatory rheometer.
This test method is applicable for fresh, as well as used, lubricating greases where only small quantities of the grease are present and the worked penetration that is usually used cannot be determined due to the small quantity.
The determined calibration is only valid for metal-saponified lubricating greases like lithium, lithium-calcium and, also, lithium- and calcium complex.
The method described in this document is applicable for lubricating greases with NLGI grades 00, 0, 1, 2 and 3 according to ISO 6743-99.
Best Sellers
GSO 150-2:2013
Gulf Standard
Expiration dates for food products - Part 2 :
Voluntary expiration dates
YSMO GSO 150-2:2020
GSO 150-2:2013
Yemeni Technical Regulation
Expiration dates for food products - Part 2 :
Voluntary expiration dates
YSMO GSO 2055-1:2020
GSO 2055-1:2015
Yemeni Standard
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements
Recently Published
ISO 6182-18:2025
International Standard
Fire protection — Automatic sprinkler system — Part 18: Requirements and test methods for flexible sprinkler hose
ISO 8426-1:2025
International Standard
Hydraulic fluid power — Determination of derived displacement of positive displacement pumps and motors — Part 1: Two-step Toet method
ISO 21121:2025
International Standard
Spices and condiments — Dried lime (whole, slices and ground) — Specification
ISO 15614-2:2025
International Standard
Specification and qualification of welding procedures for metallic materials — Welding procedure test — Part 2: Arc welding of aluminium and its alloys