ISO 6804:2023
International Standard
Current Edition
·
Approved on
25 May 2023
Rubber and plastics inlet hoses and hose assemblies for washing-machines and dishwashers — Specification
ISO 6804:2023 Files
English
13 Pages
Current Edition
122.46 USD
ISO 6804:2023 Scope
This document specifies the requirements for three types of rubber or plastics inlet hoses and hose assemblies for washing-machines and dishwashers connected to the domestic water supply at a pressure not exceeding 1 MPa (10 bar).
This document is applicable to the following types of hose:
— type 1: rubber hoses for unheated water supply (maximum temperature 70 °C);
— type 2: rubber hoses for heated water supply (maximum temperature 90 °C);
— type 3: plastics hoses for unheated water supply (maximum temperature 60 °C).
NOTE National requirements for hose fittings and hoses conveying drinking water can apply.
Best Sellers
GSO 150-2:2013
Gulf Standard
Expiration dates for food products - Part 2 :
Voluntary expiration dates
YSMO GSO 150-2:2020
GSO 150-2:2013
Yemeni Technical Regulation
Expiration dates for food products - Part 2 :
Voluntary expiration dates
YSMO GSO 2055-1:2020
GSO 2055-1:2015
Yemeni Standard
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements
Recently Published
ISO 18777-2:2025
International Standard
Transportable liquid oxygen systems for medical use — Part 2: Particular requirements for portable units
ISO/IEC 29110-5-2-1:2025
International Standard
Systems and software engineering — Life cycle profiles for very small entities (VSEs) — Part 5-2-1: Organizational management guidelines
ISO/IEC 18047-6:2025
International Standard
Information technology — Radio frequency identification device conformance test methods — Part 6: Test methods for air interface communications at 860 MHz to 930 MHz
ISO/TS 4452:2025
International Standard
Specification and demonstration of system reliability of single-use drug delivery systems