ISO 23551-5:2023

International Standard   Current Edition · Approved on 18 October 2023

Safety and control devices for gas burners and gas-burning appliances — Particular requirements — Part 5: Manual gas valves

ISO 23551-5:2023 Files

English 33 Pages
Current Edition
192.78 USD

ISO 23551-5:2023 Scope

This document specifies safety, constructional and performance requirements for manual gas valves intended for use with gas burners and gas-burning appliances, hereafter referred to as "valves", unless otherwise specified.

This document applies to the following types of manual gas valves:

     manual gas shut-off valves;

     gas burner valves;

     appliance connector valves;

     delta C valves.

This document applies to valves for gas burners and gas-burning appliances of nominal connection size up to and including DN 100 that can be used and tested independently of these appliances using fuel gases, as natural gas, manufactured gas or liquefied petroleum gas (LPG) at inlet pressures up to and including 500 kPa.

This document is not applicable to corrosive and waste gases.

This document covers type testing only.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
YSMO GSO 150-2:2020
GSO 150-2:2013 
Yemeni Technical Regulation
Expiration dates for food products - Part 2 : Voluntary expiration dates
YSMO GSO 2055-1:2020
GSO 2055-1:2015 
Yemeni Standard
HALAL FOOD - Part 1 : General Requirements
GSO 2055-1:2015
 
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements

Recently Published

ISO 6182-18:2025
 
International Standard
Fire protection — Automatic sprinkler system — Part 18: Requirements and test methods for flexible sprinkler hose
ISO 8426-1:2025
 
International Standard
Hydraulic fluid power — Determination of derived displacement of positive displacement pumps and motors — Part 1: Two-step Toet method
ISO 21121:2025
 
International Standard
Spices and condiments — Dried lime (whole, slices and ground) — Specification
ISO 15614-2:2025
 
International Standard
Specification and qualification of welding procedures for metallic materials — Welding procedure test — Part 2: Arc welding of aluminium and its alloys