ISO 22042:2021

International Standard   Current Edition
· Approved on 31 March 2021 ·

Blast chiller and freezer cabinets for professional use — Classification, requirements and test conditions

Commercial refrigerating appliances
Including refrigerated display cabinets, cold rooms, etc.

ISO 22042:2021 Files

English 10 Pages
Current Edition
73.38 USD

ISO 22042:2021 Scope

This document specifies the requirements for the verification of performance and energy consumption of blast cabinets for professional use in commercial kitchens, hospitals, canteens, institutional catering and similar professional areas.

The appliances covered by this document are intended to rapidly cool down hot foodstuffs up to a load capacity of 300 kg.

This document applies to:

—    blast chillers;

—    blast freezers;

—    multi-use blast chillers/freezers.

The following appliances are not covered:

—    roll-in cabinet;

—    pass-through cabinet;

—    cabinets with remote condensing unit;

—    cabinets with water cooled condenser;

—    blast chilling and freezing tunnels;

—    continuous blast-chilling and blast-freezing equipment;

—    bakery combined freezing and storage units.

Best Sellers

GSO 150-2:2013
 
Gulf Standard
Expiration dates for food products - Part 2 : Voluntary expiration dates
YSMO GSO 150-2:2020
GSO 150-2:2013 
Yemeni Technical Regulation
Expiration dates for food products - Part 2 : Voluntary expiration dates
GSO 2055-1:2015
 
Gulf Technical Regulation
HALAL FOOD - Part 1 : General Requirements
YSMO GSO 150-1:2020
GSO 150-1:2013 
Yemeni Technical Regulation
Expiration dates for food products -Part 1 : Mandatory expiration dates

Recently Published

ISO 10319:2024
 
International Standard
Geosynthetics — Wide-width tensile test
ISO 18893:2024
 
International Standard
Mobile elevating work platforms — Safety principles, inspection, maintenance and operation
ISO 9842:2024
 
International Standard
Essential oil of rose (Rosa x damascena Miller)
ISO 5459:2024
 
International Standard
Geometrical product specifications (GPS) — Geometrical tolerancing — Datums and datum systems