GSO EN 14801:2024
EN 14801:2006
Gulf Standard
Current Edition
·
Approved on
25 April 2024
Conditions for pressure classification of products for water and wastewater pipelines
GSO EN 14801:2024 Files
English
26 Pages
Current Edition
Reference Language
Obtaining this standard through the store is currently unavailable. You can acquire it directly from its source.
GSO EN 14801:2024 Scope
This document applies to components (pipes, joints, fittings, ferrules and valves), which have pressure related classification in European Standards covering products which are intended to be used for buried water supply and waste water pressure pipelines outside buildings. It specifies combinations of loading conditions and installation conditions to be used in the design method by reference to the relevant product standard for the determination of the allowable pressures (PFA, PMA and PEA) as defined in EN 805.
This document does not apply as an installation guide.
NOTE 1 This document does not give the full range of installation and loading parameters for all components and does not specify calculation and/or test methods for determination of the allowable pressures.
NOTE 2 This document does not relieve designers of their obligation under EN 805:2000, 8.4; e.g. to consider all conditions not addressed in clause 5 (e. g. seismic loads).
NOTE 3 This document does not deal with marking of components.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ISO 5393:2026
ISO 5393:2017
Gulf Standard
Rotary tools for threaded fasteners — Performance test method
GSO ISO 11681-2:2026
ISO 11681-2:2022
Gulf Standard
Machinery for forestry — Portable chain-saw safety requirements and testing — Part 2: Chain-saws for tree service
GSO ISO 8741:2026
ISO 8741:2025
Gulf Standard
Fasteners — Reverse-taper grooved pins — Half-length progressive grooves
GSO ISO 8740:2026
ISO 8740:2025
Gulf Standard
Fasteners — Parallel grooved pins, with chamfer point — Full-length diamond grooves