GSO EN 14960-2:2024
EN 14960-2:2019
Gulf Standard
Current Edition
·
Approved on
31 January 2024
Inflatable play equipment - Part 2: Additional safety requirements for inflatable bouncing pillows intended for permanent installation
GSO EN 14960-2:2024 Files
No files are available for this standard right now!
GSO EN 14960-2:2024 Scope
This part of EN 14960 specifies additional safety requirements for inflatable bouncing pillows intended for permanent installation.
This part of EN 14960 is applicable to inflatable play equipment intended for use by children fourteen years and under, both individually and collectively.
This part of EN 14960 specifies safety requirements for inflatable play equipment for which the primary activity is bouncing. It sets measures to address risks and also to minimize accidents to users for those involved in the design, manufacture and supply of inflatable play equipment.
It specifies information to be supplied with the equipment. The requirements have been laid down bearing in mind the risk factor based on available data.
This part of EN 14960 specifies the requirements that will protect a child from hazards that he or she might be unable to foresee when using the equipment as intended, or in a manner that can be reasonably anticipated.
This part of EN 14960 is not applicable to inflatables dealt with in EN 14960 1:2019, inflatable water-borne play and leisure equipment, domestic inflatable toys, air-supported buildings, inflatables used solely for protection, inflatables used for rescue, or other types of inflatable toys where the primary activity is not bouncing or sliding.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022
Gulf Standard
Gas cylinders
— Compatibility of cylinder and valve materials with gas contents
— Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021
Gulf Standard
Furniture
— Tests for surface finishes
— Part 5: Assessment of resistance to abrasion