GSO EN 12261:2023
Gulf Standard
Current Edition
·
Approved on
10 September 2023
·
Gas meters - Turbine gas meters
GSO EN 12261:2023 Files
No files are available for this standard right now!
GSO EN 12261:2023 Scope
This document specifies the measuring conditions, requirements and tests for the construction, performance and safety of class 1,0 axial and radial turbine gas meters with mechanical indicating devices, herein after referred to as a meter(s), having in-line pipe connections for gas flow measurement.
This document applies to turbine gas meters used to measure the volume of fuel gases of the 1st and 2nd gas families, the composition of which is specified in EN 437, at maximum working pressures up to 420 bar, actual flow rates up to 25 000 m³/h over a gas temperature range of at least 40 K and for a climatic environmental temperature range of at least 50 K.
This document applies to meters that are installed in locations with vibration and shocks of low significance and in
- closed locations (indoor or outdoor with protection as specified by the manufacturer) with condensing or with non-condensing humidity
or, if specified by the manufacturer,
- open locations (outdoor without any covering) with condensing humidity or with non-condensing humidity
and in locations with electromagnetic disturbances.
Unless otherwise specified in this document:
- all pressures used are gauge;
- all influence quantities, except the one under test, are kept relatively constant at their reference value.
Best Sellers From Metrology Sector
GSO OIML R87:2021
OIML R87:2016
Gulf Standard
Quantity of product in prepackages
GSO OIML R79:2021
OIML R79:2015
Gulf Standard
Labeling requirements for prepackages
GSO OIML R 76-1:2009
OIML R 76-1:2006
Gulf Standard
Non-automatic weighing instruments –
Part 1: Metrological and technical requirements - Tests
GSO OIML R111-1:2007
OIML R111-1:2004
Gulf Standard
Weights of classes E1, E2,F1,F2,M1,M1-2,M2,M2-3 and M3
Part 1: Metrological and Technical requirements
Recently Published from Metrology Sector
GSO IEC 62828-4:2024
IEC 62828-4:2020
Gulf Standard
Reference conditions and procedures for testing industrial and process measurement transmitters - Part 4: Specific procedures for level transmitters
GSO ISO 748:2024
ISO 748:2021
Gulf Standard
Hydrometry — Measurement of liquid flow in open channels — Velocity area methods using point velocity measurements
GSO ISO 14405-2:2024
ISO 14405-2:2018
Gulf Standard
Geometrical product specifications (GPS) — Dimensional tolerancing — Part 2: Dimensions other than linear or angular sizes
GSO ISO 3455:2024
ISO 3455:2021
Gulf Standard
Hydrometry — Calibration of current-meters in straight open tanks