GSO ISO 25649-1:2021

ISO 25649-1:2017
Gulf Standard   Current Edition · Approved on 01 July 2021

Floating leisure articles for use on and in the water — Part 1: Classification, materials, general requirements and test methods

GSO ISO 25649-1:2021 Files

GSO ISO 25649-1:2021 Scope

ISO 25649-1:2017 specifies safety requirements and test methods related to materials, safety, performance for classified floating leisure articles for use on and in water in accordance with Clause 4 (see Table 1).

ISO 25649-1:2017 is only applicable with ISO 25649‑2 and the relevant specific parts (ISO 25649‑3 to ISO 25649‑7).

NOTE 1 Specific safety requirements are specified in ISO 25649‑3 to ISO 25649‑7.

NOTE 2 The specific parts can include exclusions from the general requirements specified in this document and/or ISO 25649‑2.

ISO 25649-1:2017 is not applicable to:

- aquatic toys according to European Directive 2009/48/EC (use in shallow waters/use under supervision);

- inflatable boats with a buoyancy > 1 800 N according to European Directive 94/25/EC;

- buoyant aids for swimming instructions according to European Directive 89/686/EEC;

- air mattresses which are not specifically designed or intended for use on the water (e.g. velour bed, self inflating mattress and rubberized cotton air mattress);

- floating seats for angling purposes;

- surf sports type devices (e.g. body boards, surf boards);

- water ski, wakeboard or kite surfing board;

- devices made from rigid materials e.g. wood, aluminium, hard or non-deformable plastic;

- devices which are kept in shape by permanent air flow;

- rings intended for use on water slides;

- wading devices.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 1780:2010
 
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements

Recently Published from Mechanical Sector

GSO ISO 10468:2024
ISO 10468:2023 
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes — Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023 
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022 
Gulf Standard
Gas cylinders — Compatibility of cylinder and valve materials with gas contents — Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021 
Gulf Standard
Furniture — Tests for surface finishes — Part 5: Assessment of resistance to abrasion