GSO ISO 6526:2016
ISO 6526:1983
Gulf Standard
Current Edition
·
Approved on
22 December 2016
Plain bearings -- Pressed bimetallic half thrust washers -- Features and tolerances
GSO ISO 6526:2016 Files
English
6 Pages
Current Edition
Reference Language
70.52 USD
GSO ISO 6526:2016 Scope
This International Standard specifies the main features and lays down tolerances for pressed bimetallic half thrust washers having an outside diameter up to 160 mm.
NOTES
1 All the linear dimensions and tolerances are expressed in millimetres.
2 The main dimensions for the half thrust washers are not the subject of an International Standard.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors