GSO ISO 21940-13:2016

ISO 21940-13:2012 
Gulf Standard   Current Edition
· Approved on 22 December 2016 ·

Mechanical vibration -- Rotor balancing -- Part 13: Criteria and safeguards for the in-situ balancing of medium and large rotors

GSO ISO 21940-13:2016 Files

English 23 Pages
Current Edition Reference Language
149.41 USD

GSO ISO 21940-13:2016 Scope

This part of ISO 21940 specifies procedures to be adopted when balancing medium and large rotors installed in their own bearings on site. It addresses the conditions under which it is appropriate to undertake in-situ balancing, the instrumentation required, the safety implications and the requirements for reporting and maintaining records. This part of ISO 21940 can be used as a basis for a contract to undertake in-situ balancing. It does not provide guidance on the methods used to calculate the correction masses from measured vibration data. NOTE The procedures covered in this part of ISO 21940 are suitable for medium and large machines. However, many of the principles are equally applicable to machines of a smaller size, where it is necessary to maintain good records of the vibration behaviour and the correction mass configurations.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 1780:2010
 
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements

Recently Published from Mechanical Sector

GSO ISO 23598:2024
ISO 23598:2021 
Gulf Standard
Mechanical joining of sheet materials — Destructive testing of joints — Specimen dimensions and procedure for mechanized peel testing of single joints
GSO ISO 9093:2024
ISO 9093:2020 
Gulf Standard
Small craft — Seacocks and through-hull fittings
GSO ISO 22407:2024
ISO 22407:2021 
Gulf Standard
Metallic materials — Fatigue testing — Axial plane bending method
GSO ISO 21384-2:2024
ISO 21384-2:2021 
Gulf Standard
Unmanned aircraft systems — Part 2: UAS components