GSO ISO 3503:2016
ISO 3503:2015
Gulf Standard
Current Edition
·
Approved on
27 September 2016
Plastics piping systems -- Mechanical joints between fittings and pressure pipes -- Test method for leaktightness under internal pressure of assemblies subjected to bending
GSO ISO 3503:2016 Files
English
5 Pages
Current Edition
Reference Language
47.01 USD
GSO ISO 3503:2016 Scope
ISO 3503:2015 specifies a method for checking the leak tightness under internal pressure of assembled joints between mechanical fittings and plastic pressure pipes when subjected to bending. It defines the calculation method for the average bending radius and how to perform this bending.
Checking of the leak tightness under internal pressure is carried out in accordance with the method given in ISO 3458.
This test method is not applicable to fusion-welded joints.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO EN 13445-6:2024
EN 13445-6:2021
Gulf Standard
Unfired pressure vessels - Part 6: Requirements for the design and fabrication of pressure vessels and pressure parts constructed from spheroidal graphite cast iron
GSO ISO 11154:2024
ISO 11154:2023
Gulf Standard
Road vehicles — Roof load carriers
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors