GSO IEC 60381-2:2015
IEC 60381-2:1978
Gulf Standard
Current Edition
·
Approved on
03 September 2015
Analogue signals for process control systems. Part 2: Direct voltage signals
GSO IEC 60381-2:2015 Files
English
9 Pages
Current Edition
Reference Language
Obtaining this standard through the store is currently unavailable. You can acquire it directly from its source.
GSO IEC 60381-2:2015 Scope
This standard specifies analogue direct voltage signals used in industrial process measurement and control systems to transmit information between the elements of systems. Contrary to the analogue direct current signal as specified in I E C Publication 381, Analogue D.C. Current Signals for Process Control Systems, the analogue direct voltage signal is not intended for transmission over long distances.
This standard does not apply to signals used entirely within an element.
Best Sellers From Electrical Sector
YSMO GSO 2530:2023
GSO 2530:2016
Yemeni Technical Regulation
Energy Labelling And Minimum Energy Performance Requirements For Air-Conditioners
GSO 2530:2016
Gulf Standard
Energy Labelling And Minimum Energy Performance Requirements For Air-Conditioners
GSO 34:2007
Gulf Technical Regulation
LEAD-ACID STARTER BATTERIES USED FOR
MOTOR VEHICLES AND INTERNAL
COMBUSTION ENGINES
GSO 35:2007
Gulf Standard
Methods of test
for lead-acid starter batteries used for motor vehicles
and internal combustion engines
Recently Published from Electrical Sector
GSO IEC 63522-32:2026
IEC 63522-32:2025
Gulf Standard
Electrical relays - Tests and measurements - Part 32: Acoustic noise
GSO IEC 61643-41:2026
IEC 61643-41:2025
Gulf Standard
Low-voltage surge protective devices - Part 41: Surge protective devices connected to DC low-voltage power systems – Requirements and test methods
GSO IEC TS 62600-100:2026
IEC TS 62600-100:2024
Gulf Standard
Marine energy - Wave, tidal and other water current converters - Part 100: Electricity producing wave energy converters - Power performance assessment
GSO ISO 9059:2026
ISO 9059:2025
Gulf Standard
Solar energy — Calibration of pyrheliometers by comparison to a reference pyrheliometer
