GSO IEC 60444-2:2015
IEC 60444-2:1980
Gulf Standard
Current Edition
·
Approved on
03 September 2015
Measurement of quartz crystal unit parameters by zero phase technique in a pi-network. Part 2: Phase offset method for measurement of motional capacitance of quartz crystal units
GSO IEC 60444-2:2015 Files
English
18 Pages
Current Edition
Reference Language
Obtaining this standard through the store is currently unavailable. You can acquire it directly from its source.
GSO IEC 60444-2:2015 Scope
This standard describes a method of measuring the motional capacitance of quartz crystal units in the frequency range 1 MHz to 125 MHz with a total measurement error of the order of 5%.
The advantage of this method is that it uses only the measuring circuit described in I E C Publication 444 and therefore avoids the use of additional elements or instruments which could be sources of error.
Best Sellers From Electrical Sector
YSMO GSO 2530:2023
GSO 2530:2016
Yemeni Technical Regulation
Energy Labelling And Minimum Energy Performance Requirements For Air-Conditioners
GSO 2530:2016
Gulf Standard
Energy Labelling And Minimum Energy Performance Requirements For Air-Conditioners
GSO 34:2007
Gulf Technical Regulation
LEAD-ACID STARTER BATTERIES USED FOR
MOTOR VEHICLES AND INTERNAL
COMBUSTION ENGINES
GSO 35:2007
Gulf Standard
Methods of test
for lead-acid starter batteries used for motor vehicles
and internal combustion engines
Recently Published from Electrical Sector
GSO 2693:2026
Gulf Technical Regulation
The GCC Terrestrial Radio Receiver Specifications for AM/FM/T-DAB+
GSO IEC 60335-2-79:2026
IEC 60335-2-79:2021
Gulf Standard
Household and similar electrical appliances - Safety - Part 2-79: Particular requirements for high pressure cleaners and steam cleaners
GSO IEC TS 63542:2026
IEC TS 63542:2024
Gulf Standard
Refrigerant detection systems for flammable refrigerants
GSO IEC 62841-2-9:2026
IEC 62841-2-9:2015
Gulf Standard
Electric motor-operated hand-held tools, transportable tools and lawn and garden machinery - Safety - Part 2-9: Particular requirements for hand-held tappers and threaders