GSO ISO 2283:2015
ISO 2283:2000
Gulf Standard
Current Edition
·
Approved on
03 September 2015
Long shank taps with nominal diameters from M3 to M24 and 1/8 in to 1 in -- Reduced shank taps
GSO ISO 2283:2015 Files
English
7 Pages
Current Edition
Reference Language
USD
81.65
GSO ISO 2283:2015 Scope
This International Standard specifies the dimensions for reduced shank taps with nominal diameters from M3 to M24 and 1/8 in to 1 in and thus complements ISO 8051 which concerns full-diameter shank taps.
It applies to long shank machine taps.
Technical specifications for taps covered by this International Standard (including marking) are given in ISO 8830.
This International Standard is applicable to taps intended for cutting the following threads:
a) ISO metric threads
— coarse pitch;
— fine pitch.
b) ISO inch threads
— "Unified Coarse" series (UNC) and "Unified Fine" series (UNF).
The following non-recommended inch threads
— "British Standard Whitworth" (BSW) and"British Standard Fine" (BSF);
— "British Association" (BA)
are given in Annex A.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 2698:2022
Gulf Standard
Technical Requirements for Electric Vehicles
Recently Published from Mechanical Sector
GSO 230:2005
Gulf Standard
MOTOR VEHICLES —
BRAKE FLUID – SIMULATED SERVICE
PERFORMANCE TEST
GSO 1796:2007
Gulf Standard
Methods of test for two pieces aluminum round cans used for canning food (Beverages & stuffs
GSO 1584:2002
Gulf Standard
Agricultoral equipment - roll over protection structures for agricultural tractors.
GSO ISO 581:1997
ISO 581:1980
Gulf Standard
Weldability- definition .
