GSO ISO 5414-2:2015
ISO 5414-2:2002
Gulf Standard
Current Edition
·
Approved on
03 September 2015
Tool chucks (end mill holders) with clamp screws for flatted cylindrical shank tools -- Part 2: Connecting dimensions of chucks and designation
GSO ISO 5414-2:2015 Files
English
10 Pages
Current Edition
Reference Language
USD
80.69
GSO ISO 5414-2:2015 Scope
This part of ISO 5414 specifies the dimensions of tool chucks (end mill holders) with clamp screws for tools with flatted cylindrical shanks in accordance with ISO 3338-2. It also specifies the designations of these chucks.
Two types of connection are defined:
— chucks with 7/24 taper shanks in accordance with ISO 297 for manual changers and with ISO 7388-1 for automatic changers, for tool shanks with either single flat or a double flat for manual and automatic changers;
NOTE 1 This part of ISO 5414 specifies the dimensions of tool chucks with 7/24 taper shanks No. 30 for automatic changers although these are not standardized.
— chucks with Morse taper shanks in accordance with ISO 296 and ISO 5413 for tool shanks with a single flat only.
NOTE 2 The dimensions of the driving system of the tool shanks are dealt with in ISO 5414-1.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 2698:2022
Gulf Standard
Technical Requirements for Electric Vehicles
Recently Published from Mechanical Sector
GSO ISO 8741:2026
ISO 8741:2025
Gulf Standard
Fasteners — Reverse-taper grooved pins — Half-length progressive grooves
GSO ISO 8740:2026
ISO 8740:2025
Gulf Standard
Fasteners — Parallel grooved pins, with chamfer point — Full-length diamond grooves
GSO ISO 34505:2026
ISO 34505:2025
Gulf Standard
Road vehicles — Test scenarios for automated driving systems — Scenario evaluation and test case generation
GSO ISO 10972-1:2026
ISO 10972-1:2025
Gulf Standard
Cranes — Requirements for mechanisms — Part 1: General