GSO ISO 10897:2015
ISO 10897:1996
Gulf Standard
Current Edition
·
Approved on
03 September 2015
Collets for tool holders with taper ratio 1:10 -- Collets, hoders,nuts
GSO ISO 10897:2015 Files
English
12 Pages
Current Edition
Reference Language
USD
81.64
GSO ISO 10897:2015 Scope
This International Standard specifies the dimensions, materials and manufacturing requirements, and designation of collets for tools with cylindrical shanks and their corresponding holders and nuts. For non-standardized clamping devices, such as clamping devices specified in drawings, these holders can be agreed upon between customer and supplier.
Form A applies where a clamping range of h10 is sufficient.
Form В can be used for any application without lateral cutting load.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 2698:2022
Gulf Standard
Technical Requirements for Electric Vehicles
Recently Published from Mechanical Sector
GSO 1796:2007
Gulf Standard
Methods of test for two pieces aluminum round cans used for canning food (Beverages & stuffs
GSO 230:2005
Gulf Standard
MOTOR VEHICLES —
BRAKE FLUID – SIMULATED SERVICE
PERFORMANCE TEST
GSO 1584:2002
Gulf Standard
Agricultoral equipment - roll over protection structures for agricultural tractors.
GSO 137:1991
Gulf Standard
Plastics and cellular plastics – Part 1: standard atmospheres for Conditioning and testing, Determination of linear dimensions and Test for dimensional stability