GSO ISO 19840:2014

ISO 19840:2012
Gulf Standard   Current Edition · Approved on 25 December 2014

Paints and varnishes -- Corrosion protection of steel structures by protective paint systems -- Measurement of, and acceptance criteria for, the thickness of dry films on rough surfaces

GSO ISO 19840:2014 Files

English 16 Pages
Current Edition Reference Language
115.18 USD

GSO ISO 19840:2014 Scope

This International Standard specifies a procedure for the verification of dry-film thickness against nominal dry-film thickness on rough surfaces, including the adjustment of the instruments used, the definition of inspection areas, sampling plans, measurement methods and acceptance/rejection criteria. For the purposes of this standard, any specified thickness is taken to be nominal as defined in ISO 12944-5, and the dry-film thickness is the typical thickness above the peaks of the surface profile. The procedure described in this International Standard is based on the use of instruments of the permanent magnet, electromagnet and eddy current type. Instrument accuracy is verified both at zero and at a known thickness on a smooth surface and adjusted if necessary. Measurements taken on a coating on a roughened steel substrate will therefore be higher than the actual value above the peaks of the profile. The thickness of the dry film above the peaks of the profile is defined as the instrument reading minus an appropriate correction value. The dry-film thickness is obtained by using the appropriate correction value applied to readings based on adjustment on a smooth, flat steel surface. Where individual readings, based on adjustment on a smooth, flat steel surface without the use of correction values, are specified or agreed, it is important to recognize that this method does not conform with this International Standard. This standard is applicable if the nominal dry-film thickness is 40 µm or greater. NOTE If the nominal thickness is less than the surface roughness of the substrate, the uncertainty of the measurement will increase.

Best Sellers From Chemical and Textile Sector

GSO 1943:2024
 
Gulf Technical Regulation
Cosmetic Products – Safety Requirements of Cosmetics and Personal Care Products
GSO 151:2022
 
Gulf Standard
Synthetic Detergents –Household Synthetic Detergents Powder
GSO 575:2016
 
Gulf Standard
Facial tissue - paper
GSO 2555:2021
 
Gulf Technical Regulation
General Safety Requirements of Household Detergents

Recently Published from Chemical and Textile Sector

YSMO GSO 802:2024
GSO 802:2023 
Yemeni Standard
Sodium Hypochlorite Solution for Domestic Uses
YSMO GSO 2716:2024
GSO 2716:2023 
Yemeni Standard
Adult Diapers for Single-Use
YSMO GSO 1217:2024
GSO 1217:2022 
Yemeni Standard
Cosmetic products – Hair oils
GSO ISO 5631-3:2024
ISO 5631-3:2022 
Gulf Standard
Paper and board — Determination of colour by diffuse reflectance — Part 3: Indoor illumination conditions (D50/2°)