GSO IEC 61097-8:2014
IEC 61097-8:1998
Gulf Standard
Current Edition
·
Approved on
25 December 2014
Global maritime distress and safety system (GMDSS) - Part 8: Shipborne watchkeeping receivers for the reception of digital selective calling (DSC) in the maritime MF, MF/HF and VHF bands - Operational and performance requirements, methods of testing and required test results
GSO IEC 61097-8:2014 Files
English
38 Pages
Current Edition
Reference Language
Obtaining this standard through the store is currently unavailable. You can acquire it directly from its source.
GSO IEC 61097-8:2014 Scope
This part of IEC 61097 specifies the minimum requirements for shipborne receivers intended to be connected to an external installation, including a decoder for digital selective calling (DSC), and used as receivers for watchkeeping on DSC channels on board ships operating in the maritime mobile MF, MF/HF and VHF bands allocated in the Radio Regulations of the International Telecommunication Union (ITU) to the maritime mobile service, both in connection with distress and safety communication and in connection with general communication.
These requirements include the relevant provisions of the Radio Regulations and recommendations ITU-R M.489, and ITU-R M.541, and relevant provisions of resolutions A.694, A.803, A.804 and A.806 of the International Maritime Organization (IMO).
This standard also specifies technical characteristics, methods of testing and required test results for dedicated watchkeeping receivers for use with radio installations in the GMDSS as required by chapter IV of the International Convention for Safety of Life at Sea (SOLAS) 1974, as amended, and with which IEC 60945 is associated. When a requirement in this standard differs from IEC 60945, the requirement of this standard takes precedence.
This standard covers receivers with analogue or with digital DSC signal output interfaces or with both.
DSC watchkeeping receivers can be either fixed frequency receivers or, in MF/HF bands, scanning receivers.
They may be a separate equipment or be integrated with a DSC or radiotelephone equipment.
For integrated equipment this standard specifies the requirements and methods of testing of the DSC watchkeeping receivers only. The DSC equipment or radiotelephone shall comply with the requirements of the relevant standard, for example, IEC 61097-3 [3]*, IEC 61097-7 [4] and IEC 61097-9 [5] respectively.
NOTE – All requirements of this standard resulting from the above referenced IMO resolutions or ITU recommendations are identified by quoting the number of the IMO resolution or ITU recommendation and relevant paragraph in brackets following the requirement.
Best Sellers From Electrical Sector
YSMO GSO 2530:2023
GSO 2530:2016
Yemeni Technical Regulation
Energy Labelling And Minimum Energy Performance Requirements For Air-Conditioners
GSO 2530:2016
Gulf Standard
Energy Labelling And Minimum Energy Performance Requirements For Air-Conditioners
GSO 34:2007
Gulf Technical Regulation
LEAD-ACID STARTER BATTERIES USED FOR
MOTOR VEHICLES AND INTERNAL
COMBUSTION ENGINES
GSO 35:2007
Gulf Standard
Methods of test
for lead-acid starter batteries used for motor vehicles
and internal combustion engines
Recently Published from Electrical Sector
GSO IEC 63522-32:2026
IEC 63522-32:2025
Gulf Standard
Electrical relays - Tests and measurements - Part 32: Acoustic noise
GSO IEC 61643-41:2026
IEC 61643-41:2025
Gulf Standard
Low-voltage surge protective devices - Part 41: Surge protective devices connected to DC low-voltage power systems – Requirements and test methods
GSO IEC TS 62600-100:2026
IEC TS 62600-100:2024
Gulf Standard
Marine energy - Wave, tidal and other water current converters - Part 100: Electricity producing wave energy converters - Power performance assessment
GSO ISO 9059:2026
ISO 9059:2025
Gulf Standard
Solar energy — Calibration of pyrheliometers by comparison to a reference pyrheliometer