GSO ISO 7129:2013
ISO 7129:1997
Gulf Standard
Current Edition
·
Approved on
31 December 2013
Earth-moving machinery -- Cutting edges used on tractor-dozers, graders and scrapers -- Principal shapes and basic dimensions
GSO ISO 7129:2013 Files
English
12 Pages
Current Edition
Reference Language
USD
80.69
GSO ISO 7129:2013 Scope
This International Standard specifies
— the principal shapes and dimensions of the cross-section,
— the hole location for the mounting bolts,
— the shapes and dimensions of holes for the mounting bolts,
for cutting used on tractor-dozers, graders and scrapers, as defined in ISO 6165, taking interchangeability into consideration.
NOTE Some values in inches in this International Standard are not equivalent to the corresponding values in millimetres because widely used values have been adopted.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 2698:2022
Gulf Standard
Technical Requirements for Electric Vehicles
Recently Published from Mechanical Sector
GSO ISO 8741:2026
ISO 8741:2025
Gulf Standard
Fasteners — Reverse-taper grooved pins — Half-length progressive grooves
GSO ISO 8740:2026
ISO 8740:2025
Gulf Standard
Fasteners — Parallel grooved pins, with chamfer point — Full-length diamond grooves
GSO ISO 34505:2026
ISO 34505:2025
Gulf Standard
Road vehicles — Test scenarios for automated driving systems — Scenario evaluation and test case generation
GSO ASTM D8002:2026
ASTM D8002:24
Gulf Standard
Standard Test Method for Modified Fouling Index (MFI-0.45) of Water
