GSO ISO 9704:2013
ISO 9704:1990
Gulf Standard
Current Edition
·
Approved on
09 September 2013
Passenger cars -- Wiper systems -- Shaft ends and arm-holes
GSO ISO 9704:2013 Files
English
4 Pages
Current Edition
Reference Language
47.36 USD
GSO ISO 9704:2013 Scope
This International Standard specifies the main dimensions and general requirements for wiper arm to shaft end connections of wiper systems used on passenger cars. It also applies to wiper arm to shaft end connections of other vehicles where no specific International Standard exists.
Type 1 is the preferred type. Type 2, which is given in annex A, is still used in some countries.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS
GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS
GSO 1780:2010
Gulf Technical Regulation
Motor vehicle-vehicle identification number (vin) - requirements
Recently Published from Mechanical Sector
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions
GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors
GSO ISO 11114-5:2024
ISO 11114-5:2022
Gulf Standard
Gas cylinders
— Compatibility of cylinder and valve materials with gas contents
— Part 5: Test methods for evaluating plastic liners
GSO ISO 4211-5:2024
ISO 4211-5:2021
Gulf Standard
Furniture
— Tests for surface finishes
— Part 5: Assessment of resistance to abrasion