GSO ISO 8533:2022

ISO 8533:2019
Gulf Standard   Current Edition · Approved on 12 May 2022

Glass-reinforced thermosetting plastics (GRP) pipes and fittings — Test methods to prove the design of cemented or wrapped joints

GSO ISO 8533:2022 Files

GSO ISO 8533:2022 Scope

This document specifies methods of test for cemented or wrapped joints for buried and above ground glass-reinforced thermosetting plastics (GRP) piping systems. This document is only applicable to the joint and covers methods of test to prove its design. It assumes that the joint either is or is not intended to be subject to the effects of hydrostatic end thrust.

The tests detailed in 9.2, 9.4 to 9.6 inclusive are applicable to cemented or wrapped joints intended to be used in buried or above-ground applications. The bending tests detailed in 9.3 can be used to prove the design where joints are either intended to be used in buried applications or are intended to be used in particular above-ground situations where the tests may be considered appropriate.

With the exception of procedure detailed in 9.3, these test procedures are applicable to joints for pipes and fittings of all nominal sizes. The tests detailed in 9.3 are applicable to joints for pipes and fittings up to and including DN 600. The tests are applicable for evaluating joints intended for applications conveying liquids at temperatures specified in the referring standards.

The test procedures in this document are damaging to the test piece, which will not be suitable for reuse after these tests. The test procedure is applied for type testing purposes only.

This document is applicable only to the joint and specifies methods of test to prove its design.

Best Sellers From Mechanical Sector

GSO 42:2015
 
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS
GSO 159:1993
 
Gulf Technical Regulation
MOTOR VEHICLES – DIMENSIONS AND WEIGHTS
GSO 98:1988
 
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF INTERIOR MATERIALS AND THEIR TESTING METHODS
GSO 2698:2022
 
Gulf Standard
Technical Requirements for Electric Vehicles

Recently Published from Mechanical Sector

GSO EN 13077:2024
EN 13077:2023 
Gulf Standard
Devices to prevent pollution by backflow of potable water - Air gap with non-circular overflow (unrestricted) - Family A - Type B
GSO ASTM E2218:2024
ASTM E2218:23 
Gulf Standard
Standard Test Method for Determining Forming Limit Curves
GSO ASTM E213:2024
ASTM E213:22 
Gulf Standard
Standard Practice for Ultrasonic Testing of Metal Pipe and Tubing
GSO EN 13445-8:2024
EN 13445-8:2021 
Gulf Standard
Unfired pressure vessels - Part 8: Additional requirements for pressure vessels of aluminium and aluminium alloys