GSO ISO 8829-1:2016
ISO 8829-1:2009
Gulf Standard
Current Edition
·
Approved on
22 December 2016
Aerospace -- Test methods for polytetrafluoroethylene (PTFE) inner-tube hose assemblies -- Part 1: Metallic (stainless steel) braid
GSO ISO 8829-1:2016 Files
English
19 Pages
Current Edition
Reference Language
153.67 USD
GSO ISO 8829-1:2016 Scope
This part of ISO 8829 specifies test methods for flexible polytetrafluoroethylene (PTFE) inner tubes with metallic (stainless steel) braided hose and hose assemblies used in aircraft fluid systems, in the pressure and temperature ranges covered by pressure classes and temperature types, as specified in ISO 6771.
If performance requirements are not defined in this part of ISO 8829, they are defined in the performance specification.
This part of ISO 8829 is applicable when reference is made to it in a procurement specification or other definition document.
NOTE Fluids used for the tests are listed in Annex A. The requirements for non-metallic braid hose assemblies are given in ISO 8829-2.
Best Sellers From Mechanical Sector
GSO 42:2015
Gulf Technical Regulation
MOTOR VEHICLES - GENERAL REQUIREMENTS

GSO 159:1993
Gulf Technical Regulation
MOTOR VEHICLES –
DIMENSIONS AND WEIGHTS

GSO 98:1988
Gulf Technical Regulation
MOTOR VEHICLES- FLAMMABILITY OF
INTERIOR MATERIALS AND THEIR
TESTING METHODS

GSO 2698:2022
Gulf Standard
Technical Requirements for Electric Vehicles

Recently Published from Mechanical Sector
GSO ISO 10468:2024
ISO 10468:2023
Gulf Standard
Glass-reinforced thermosetting plastics (GRP) pipes
— Determination of the ring creep properties under wet or dry conditions


GSO ISO 10300-1:2024
ISO 10300-1:2023
Gulf Standard
Calculation of load capacity of bevel gears — Part 1: Introduction and general influence factors


GSO ISO 11114-5:2024
ISO 11114-5:2022
Gulf Standard
Gas cylinders
— Compatibility of cylinder and valve materials with gas contents
— Part 5: Test methods for evaluating plastic liners


GSO ISO 4211-5:2024
ISO 4211-5:2021
Gulf Standard
Furniture
— Tests for surface finishes
— Part 5: Assessment of resistance to abrasion

